Advertisement
STEP10: iNSTALL TILTSTOP BRACKETS
(SEEFIGURE 9)
,
Install a tiltstopbracket (QQ)toeachsideofthe
bucket u sing a 1/4"x 3/4"carriage bolt(L),1/4"
washer ( DD)and1/4"nylock nut(U)= Donot tighten
thenutsuntilstep27=
TmLTSTOP
BRACKET (QQ)
1/4" NYLOCK
NUT(U)
1/4" x 3/4" J'_
1/4" WASHER (DO)
CARRIAGE BOLT (L)
STEP 12: iNSTALL LiFT HANDLE TUBE EXTENSION
(SEE FIGURE 11 }
Insta!l the lift handle tube extension on the tift handle
tube using a 1/4" x 1o3/4" hex bolt (H) and 1/4" nylock
nut (U)=
LIFT HANDLE
TUBE EXTENSION
1/4" NYLOCK NUT
1/4" x 1-3/4"
HEX BOLT (H)
LIFT HANDLE
_
TUBE
FIGURE 11
FIGURE 9
STEP 11 : iNSTALL LiFT HANDLE TUBE
(SEE FIGURE 10)
Install the lift handle tube into the index bracket using
two 5/16" x 1-3/4" hex bolts (G) and 5/16" nylock nuts
(T)=
LIFT HANDLE
TUBE
5/16" NYLOCK
5/16" x 1-3/4"
NUTS (T)
HEX BOLT (G)
/
INDEX
BRACKET
FIGURE 10
STEP 13: iNSTALL LiFT CABLE
(SEE FIGURE 12)
,
Connect the hooked end of the lift cable into the index
rod, and install the threaded cable adjuster into the
notch in the top of the index bracket, placing a nut on
each side of the notch=
Adjust the cable adjustment nuts so that when the lift
trigger is squeezed, the bottom of the index rod raises
enough to release from the latched position= The index
rod should also lower far enough to lock in the latched
position when the trigger is released=
Attach the lift cable to the lift handle using three cable
ties (PP)=
LiFT TRUGGER
\
LIFT CABLE
CABLE
NUTS
INDEX ROD
FIGURE 12
10
Advertisement
