Craftsman 171.264630 Owner's Manual page 26

FINAL INSTALLATION OF THE ROUTER
ADAPTER PLATE (FIGURE 21)
1. Place the router adapter plate, with router
attached, on the leveling screws in the table top.
NOTE: Be careful not to trap the cord between
the router adapter plate and the router table top.
2. Recheck the router adapter plate to be sure it is
level, if necessary, loosen the locking nuts and
adjust the leveling screws with the allen wrench
as needed. Once the router adapter plate is
level, retighten the locking screws.
3. Secure the router adapter plate to the table
top with four #10-32 ESNA stop nuts (35) and
four #10-32 x 1" countersunk fiat-head machine
screws (37). Be sure the screws are
TIGHTENED SECURELY.
TO REMOVE THE ROUTER AND/OR ROUTER
ADAPTER PLATE
To remove the router from the adapter plate, you
must first remove the router adapter plate from the
router table.
THE FENCE MUST BE REMOVED FROM
THE ROUTER TABLE WHEN REMOVING OR
RE-INSTALLING THE ROUTER ADAPTER PLATE.
[_,WARNINGI Always make sure that the
router is NOT PLUGGED into an electrical outlet
or the switch when the router is being removed
from the router table. If it is, UNPLUG the power
cord from the outlet or the switch, and UNPLUG
the switch from the outlet.
Figure 21
!
#10-32 x 1_
countersunk
flat head screws
J
!
!
#10-32 ESNA stop nuts
1. Loosen the four #10-32 x 1" countersunk flat-head
machine screws (37) holding the router adapter
plate to the table top.
2. Lift the router adapter plate and router upwards
from the table top.
3. Remove the countersunk machine screws
securing the router to the adapter plate.
4. Be sure to check for levelness when reinstalling
the router adapter plate.
26