Download Print this page

CRAFTSMAN 171.264630 Owner's Manual Page 19

Professional router table.
Hide thumbs

Advertisement

INSTALLING
TABLE LEG INSERTS
IN THE TABLE LEGS
TABLE
LEG INSERTS
(FIGURE
10)
The router table includes two table leg inserts:
• Router bit storage panel for convenient bit storage
• Cover panel
If the table leg inserts have not been installed on the
router table legs, proceed as follows:
1. Place the table leg insert into the opening in the
table leg so that it is positioned at the very top of
the opening.
2. Press the insert in so that it is completely flush
with the leg.
3. Push the insert down as far as it will go to lock it
in place.
Figure 10
h
wn
ASSEMBLING
THE MITER GAUGE
ASSEMBLE
THE MITER GAUGE
(FIGURE
11A AND FIGURE
11B)
1, Assemble the protractor head to the miter bar, as
shown in Figure 11A, using a #10-16 x 1/2" long
type BT pan-head self-tapping screw (33).
2. Tighten the self-tapping screw into the protractor
head so that the screw touches the miter bar but
still provides resistance when the protractor head
is rotated.
NOTE: the screw will resist turning
when being
threaded into the hole as the screw is cutting
and forming a thread in the protractor head,
3. Assemble the knob, the 13/64" ID x 9/16" OD x
.040" thick washer (39), and the #10-24 x 7/8"
carriage bolt (41) to the miter bar and protractor
head as shown in Figure 11B.
4. TIGHTEN the knob SECURELY.
Figure 11A
S
-__ #10-16 x 1/2"
self-tapping
screw
,
Miter bar
ro, aotor
Figure 11B
Small clamping
knob
_
_
Washer
Protractor
#10-24 x 7/8"
\,
carriage bolt
19

Advertisement

This manual also for:

171.264640

Comments to this Manuals

Symbols: 0
Latest comments: