Download Print this page

CRAFTSMAN 171.264630 Owner's Manual Page 22

Professional router table.
Hide thumbs

Advertisement

FENCE
CLAMPING
KNOBS
(FIGURE
15)
1. Loosely install the four fence clamping knobs
through the holes in the upper fence with a
9/32" ID x 5/8" OD x 1/16" washer (40) and
1/4-20 weld nut (30) each. Be sure to note the
correct orientation of the weld nuts. DO NOT
tighten at this time.
Figure 15
END CAPS TO THE LOWER
FENCES
(FIGURE
16)
IMPORTANT: The end caps are NOT
interchangeable
and have identification
marks and alignment tabs.
1. Secure the end caps to the lower fence rails,
one at each end, with a #10-16 x 5/8" long
countersunk
Phillips head self-tapping screw (34).
NOTE: You will feel resistance when tightening
the self-tapping screws. The use of soap or a light
oil will reduce the resistance. End caps should be
attached squarely and tight against the fence rail.
Figure 16
i I
Left lower fence end cap
_
_
Lower fence
end caps
(two of each)
f
#10-16 x 5/8"
countersunk
Phillips head
self-lapping
screw
22

Advertisement

This manual also for:

171.264640

Comments to this Manuals

Symbols: 0
Latest comments: