To Install Guide Fence Brackets; To Install Post, Guard/Dust Cover With Pivot Assembly - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

INSTALL T-NUTS FROM R EAR O F RIP FENCE
T-NUT
Fig. 5 3
TO INSTALL GUIDEFENCE BRACKETS
See F/gum 54.
• To install the guide fence brackets, align each bracket
with two of the T-nuts on top of the rip fence.
NOTE=Usa the hnt two T-nuts and the back two
T-nuts leaving the one in the middle empty.
• Secure the guide fence brackets to the rip fence with
5/16 in. washers and the 5/16 in. x 1/2 in. knob bolts.
TO INSTALL POST, GUARD/DUST COVER WITH
PIVOT ASSEMBLY
See F/gum 54.
The guard/dust cover must be used in all routing opera-
tions.
• Place the spacer on the threaded end of the post and
thread the post into the remaining"i-nut.
• Tightsn the post securelywith an ad.iustab|e wrench on
the fiats on the top of the post.
• Plane the guard/dust cover with pivot assembly on the
pesL
• "Theassemblywill slide up and down on the post as
needed. Scours at the desired location by tightening
the knob nut attached to the carriagebolt.
GUARD)DUST COVER WITH
P|VO_ASEMBLY
KNOB
FLAT8 ON
KNOB
BOLTS
5/tll i.
WASHERS
CARRIAGE B OLT
GUIDE FENCE
BRACKET
T-NUTS
SPACER
RIP FENCE
Fig. 54.
38