Assembly Of Hopper Bag - Craftsman 486.24207 Owner's Manual

• Assemble t heheight a djustment handle to theheight
adjustment tubeas shown in figuresix.Usetwo
curvedheadbolts,bowed washers,
5/16"lockwashers and5/16"hexnuts.Donot
tighten yet. See figure 6.
• Assemble the grip onto the height adjustment handle.
See figure 6.
5/16" HEX NUT
5/16" LOCK
WASHER
BOWED
WASHER.
CURVED
RIP
HEIGHT
ADJUSTMENT
HANDLE
FIGURE 6
Position the height adjustment handle side to side so
that the tooth lock washer can fit between the handle
and the height adjustment strap. Tighten the nuts
securing the height adjustment handle. See figure 8.
Insert the 5/16" x 3/4" carriage bolt through the height
adjustment handle. Assemble onto the bolt, in order,
the 5/16" tooth-lock washer, the height adjustment
strap, a 5/16" flat washer and the plastic knob. See
figure 8.
5/16"FLAT
WASHER
PLASTIC 5/16" x 3/4"
KNOB CARRIAGE BOLT
TOOTH LOCK
WASHER
insert a 5/16" x 3/4" hex bolt through the angle
bracket. Assemble onto the bolt (in sequence) the
spacer bushing, the height adjustment strap, a 5/16"
flat washer and a 5/16" hex lock nut. Tighten. See
figure 7.
_16"FLAT
WASHER
_16"HEX
LOCK NUT
FIGURE 7
FIGURE 8
ASSEMBLY OF HOPPER BAG
Hold the (LH) upper hopper tube so that the hole for
the brace rod faces down. Insert the (LH) upper
hopper tube down through the stitched flap on the left
side of the hopper bag. Repeat for the right hand
upper hopper tube. See figure 7.
(LH) UPPER
HOPPER
TUBE
HOPPER
BAG
BOTTOM
FIGURE 9
6