Assembling Storage Hangers; Installing The Micro-Adjust - Craftsman 315.228590 Owner's Manual

ASSEMBLINGMDFTABLE EXTENSION
(Continued)
• At the same time, slide the belt heads into the rear
rail slot.
• Slide MDF extension table along front and rear
rails to desired location.
• Using a framing square, check to make sure MDF
extension table is level with saw table. It should be
flush or slightly below saw table.
• Loosen hex nuts as needed and adjust table using
loose play in bolt holes.
• Tighten hex nuts securely.
SAWTABLE
REARRAIL
MDF
EXTENSION
TABLE
HEX NUT
SQUARE
HEADBOLTS
WASHER Fig. 18
• On the front at the top of the leg stand, remove one
of the lower carriage bolts. See Figure 19.
• Insert carriage bolt in a small hanger and install in
front leg. Attach the washer and hex nut from the
back and tighten. Repeat for the other small
hanger.
• Install the large hangers on the left side. See
Figure 19.
INSTALLING THE MICRO-ADJUST
See Figure 20.
The micro-adjust indexes the rip fence. It includes a
gear o[i the rip fence and gear racks mounted to the
front rail.
• Locate the micro-adjust assembly, two racks, and
the following hardware:
10 pan head screws (#10-32 x 3/8 in.)
8 square nuts (#10-32)
• Hold a rack so the teeth point down and insert the
pan head screws from the bottom. Put a square
nut on each screw. Finger tighten, leaving a small
gap between the nut and the rack.
• Still holding the rack with teeth down, slide the
square nuts into the right side of the front slot of
the front rail until the end of the rack is near the
center of the table.
• Slide the other gear rack into the front rail from the
left until the two racks meet in the middle. Securely
tighten screws.
Note: The two racks must be touching for the micro-
adjust assembly to roll from one gear rack to
the other.
ASSEMBLING STORAGE HANGERS _
See Figure 19.
The large hangers are for storing the rip fence and the
small hangers are for storing the miter gage.
• Locate the storage hangers.
SMALL
STORAGE
FRONTRAIL
_ SQUARENUTS
,
i T
MICRO-ADJUST
TRACKSLOT
GEARRACK
GEARRACK
T
T
I
SCREWS Fig. 20
LARGE
STORAGEHANGER
Fig. 19
tRRFTSMRN ° TABLE SAW315.228590 24