Installing The Rear Rail - Craftsman 315.228590 Owner's Manual

10 in. stationary table saw
Table of Contents

Advertisement

INSTALLING
THE REAR
RAIL
See Figures 12, 13, and 14.
,_
WARNING:
Front and rear rails must be
carefully aligned to reduce the risk of kickback,
which can cause serious injury.
From the carton, remove the rear rail and the
following hardware:
5 square head bolts (5/16-18 x 3/4 in.)
5 hex nuts (5/16-18)
5 flat washers (5/16 in.)
Right and left end caps for rear rail
2 screws (#8-32 x 1/2 in.) for end caps
Note: Remaining hardware from this hardware bag is
used for installing the front rail, MDF table
extension, and end caps.
SQUAREHEAD
BOLT
'HEXNUT
FLATWASHER
At the back of the table, put the square head bolts
in the holes in the edge of the table and cast iron
extension so the bolt heads extend outward 1/2 in.
Under the table, loosely attach the flat washers
and hex nuts onto bolts. Slide the slot on the rear
rail over the bolts. Adjust each bolt to fit the rail
closely to the table.
Position rail so that the left hand edge extends 5 in.
beyond the table extension.
Push the rail against table and tighten each hex
nut with a 12 mm wrench. If the rail jams or does
not slide easily over the bolts, re-align the table
extension.
Note: Make sure there are no gaps between the rail
and edge of table or extension.
TABLEEXTENSION
SLOT FOR BOLT
REARRAIL
HEX NUT
SQUAREHEADBOLT
FLATWASHER
Fig. 13
5 in.
SCREW
REARRAILINSTALLED
Fig. 14
Fig. 12
CRRFTSNRH"
TABLESAW315.228590
22

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 315.228590 and is the answer not in the manual?

Questions and answers

Table of Contents