INSTALLING
THE FRONT
RAIL
See Figures 15, 16, and 17.
•
Locate the front rail, the switch assembly, and the
following hardware:
5 square head bolts (5/16-18 x 3/4 in.)
5 flat washers (5/16 in.)
5 hex nuts (5/16-18)
Right and left end caps for front rail
4 screws (#8-32 x 1/2 in.) for end caps
•
Set aside the end caps and four screws until the
MDF table extension and switch have been
installed.
•
Insert the five square head bolts into the table and
extension, so the bolt heads extend out 1/2 in.
•
Loosely attach a flat washer and a hex nut to each
bolt. See Figure 15.
•
The back of the rail has two slots, See Figure 16.
Slide the upper slot over the bolts. (Bottom slot is
for switch.)
•
Align the rail left to right - Match the 6-7/8 in. mark
on the right scale to the right edge of the saw base
(main table). See Figure 17.
•
Snug the rail against table. Finger-tighten
each nut
on the table and extension.
SCALE
RAIL SLOT
HEXNUT
FRONTRAIL
Fig. 16
TABLETOP VIEWEDFROMABOVE
SCALE
J
FRONTRAIL
HEIGHT
HANDWHEEL
SQUAREHEAD
BOLT
HEXNUT
FLAT WASHER
Fig. 15
Fig. 17
ASSEMBLING
MDF TABLE
EXTENSION
See Figure 18.
•
Locate the MDF table extension and the small
hardware bag with the following:
4
square head bolts (5/16-18 x 3/4 in.)
4
hex nuts (5/16-18)
4
flat washers (5/16 in.)
•
Insert the four square head borts into the holes
located on the front and rear edges of the MDF
table extension. The square bolt heads must
extend out.
•
Attach a flat washer and a hex nut to each bolt.
Finger-tighten each nut on the MDF table exten-
sion until head of bolt is approximately 1/8 in. from
the frame of MDF table extension. Leave just
enough clearance so that bolts do not rotate and
bind when sliding in rail slots.
•
The back of the front rail has two slots. See Figure
16. Slide the bolt heads into the upper slot of front
rail. (Bottom slot is for switch.)
23
CRRFTSMRW T ABLE SAW 315.228590
Need help?
Do you have a question about the 315.228590 and is the answer not in the manual?
Questions and answers