Checking Rip Fence And Blade Alignment - Craftsman 315.228590 Owner's Manual

10 in. stationary table saw
Table of Contents

Advertisement

CHECKING
RIP FENCE
AND
BLADE ALIGNMENT
See Figures 38, 39, and 40.
The rip fence is self-aligning
but should be checked
before first use.
WARNING:
Failure to align the rip fence to the
blade can cause jams and kickback, resulting in
serious personal injury.
Slide the rip fence to the miter gage groove, which
is parallel to blade. Do not lock the rip fence.
Place a framing square against the rip fence, with
the long end towards the front of the blade. See
Figure 38. Measure the distance from the rip fence
to the edge of the blade.
Move the square to the back of the blade and
measure the length from other end of the rip fence
to the blade. See Figure 39.
If the distances are different, loosen the four
screws around the rip fence handle with a 6 mm
hex key. Alternate the order (remove the screw
opposite, not next to the first one). See Figure 40.
Hold the fence handle against the front rail and
arign the rip fence with the blade.
Retighten the screws in alternating order and
check the alignment.
RIP FENCE
BLADE,
FRAMINGSQUARE
MITERGAGE
GROOVE
MITERGAGEGROOVE
Fig. 38
MITERGAGEGROOVE
FRAMING
SQUARE
IP FEN_
ADJUSTMENT SCREWS
RIP FENCE
Fig. 39
ADJUSTMENT
(4)
RIPFENCE
HANDLE
Fig. 40
Repeat until the rip fence is aligned.
Lock the rip fence handle in desired position by
rotating the handle down.
Note:
To insure proper self alignment when position-
ing rip fence, push sides of scale indicator
housing against front rail before locking rip
fence handle.
31
tRRFTSMAN' TABLESAW 315.228590

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 315.228590 and is the answer not in the manual?

Questions and answers

Table of Contents