Making A Miter Cut; Making A Bevel Cross Cut - Craftsman 315.228590 Owner's Manual

MAKING A MITER CUT
See Figure 64.
_, WARNING: Make sure the blade guard is
lowered over the blade and is working properly to
prevent possible injury.
Make a test cut on scrap wood. From the front of the
saw, push the wood to the blade with the miter gage.
The miter gage may be used in either of the grooves.
When using the left groove, hold the workpiece firmly
against the miter gage base with your left hand and
grip the miter gage knob with your right hand. When
using the right groove, hold the work piece with your
right hand and the miter gage knob with your left
hand.
• Check that the blade is at the correct height for the
workpiece. To change the blade height, turn the
height handwheel.
• If blade is not at 90" to the table, loosen bevel lock
handle and turn bevel handwheel. Reset bevel lock
handle.
• To set the wood angle, loosen miter gage knob, set
the angle with the indicator on the miter gage, then
retighten miter gage knob.
• Place a support the same height as top of saw
table behind the saw for cut work.
• Make sure wood is not touching the blade
before turning on the saw. Insert switch key and lift
switch to ON position. Let the blade obtain full
speed before moving the miter gage to feed the
workpiece into the blade.
MITERCUT
BLADE MITERGAGE
ANGLED
STRAIGHT __
• Hold work firmly against the miter gage and push to
feed work into the blade.
• When work is completed, press switch off and
remove switch key.
MAKING A BEVEL CROSS CUT
See Figures 65 and 66.
_lb WARNING: Make sure the blade guard is
lowered and is working properly to prevent
possible injury.
Make a test cut on scrap wood. From the front of the
saw, push the wood to the blade with the miter gage.
When using the miter gage in the left groove, hold the
workpiece firmly against the miter gage base with
your left hand and grip the miter gage knob with your
right hand. When using the right groove, hold the work
piece with your right hand.
BEVELCROSSCUT
BLADE
ANGLED
MITER
STRAIGHT
BEVELLOCK
HANDLE
HANDWHEEL
Fig. 65
• Raise rip fence handle and remove rip fence.
• Set blade angle by loosening bevel lock handle
and turning bevel handwheel until scale on the
cabinet front reads desired angle. Retighten bevel
lock handle.
HEIGHT
HANDWHEEL Fig. 64
43 CRnFTSMRN' T ABLESAW 315.228590