To Prime The Water Supply System; How The Ice Maker Works - Frigidaire FSC23F7HB4 Use & Care Manual

HOW TO PRIME THE WATER SUPPLY SYSTEM
"four refrigerator's water supply system includes several
tubing lines, a water filter, a water valve and a water tank. To
ensure that your water dispenser works propermy, this
system must be completely filled with water when your
refrigerator is first connected to the househoM water
suppmy line and whenever you replace the water filter.
TO PRIME THE WATER SUPPLY SYSTEM:
Begin filling the tank by pressing and holding a drinking
glass against the water dispenser paddle.
Keep the glass in this position until water comes out of
the dispenser. There will be noticeable spurts and
sputters as the system pushes air out through the
system and dispenser nozzle. This is normal. This may
take about 11/2 minutes.
Continue dispensing water for about 3 minutes to flush
the system of any air and impurities. Empty glass as
needed.
HOW THE iCE MAKER WORKS
cause the ice maker to cycle two or three times before making
a full tray of ice. With no usage, it will take approximately two
days to fill the ice container.
Because of new plumbing connections, the first production of
ice cubes may be discolored or have an odd flavor. Discard
ice made during the first 24 hours.
TURMNG YOUR SIDE MOUNTED raCE MAKER ON!OFF
To begin ice production, lower the wire signal arm to the
DOWN or ON position. The ice maker turns off automatically
when the ice container becomes fu!l. To stop the ice maker,
raise the wire signal arm until it clicks and locks in the UP or
OFF position (see Figure 1).
TURMNG YOUR REAR MOUNTED raCE MAKER ON/OFF
Ice production is controlled by the ice maker's ON/OFF power
switch. To gain access to the ice maker, pull the ice cream
shelf ouL Press the switch to the 'O" position to turn it Off and
press it to the 'l" position to turn it On (see Figure 2). The ice
maker also has a builtqn wire signal arm, which automatically
stops ice production when the ice bin is full. DO NOT use this
signal arm to manually stop the ice maker.
Figure t Figure 2
The ice maker and container are located in the top of the
freezer compartment. After the refrigerator is installed properly ...............................................................................................................................................................
and has cooled for several hours, the ice maker can begin
making ice within 24 hours. Air in new plumbing lines may
14