Priming The Water Supply System; To Prime The Water Supply System; Ice Maker Operation & Care; Ice Production - Frigidaire FFHS2622MSS Use & Care Manual

Table of Contents

Advertisement

Priming the Water Supply System
Your refrigerator's water supply system includes
several tubing lines, an advanced water filter,
a distribution valve bank, and a reserve tank
to ensure ample supply to the ice and water
dispenser at all times. This system needs to
be completely filled with water when first
connected to an external supply line.
Ice Maker Operation
& Care
The ice maker, ice bin, and dispenser feeding
mechanism are located in the top of the freezer
compartment.
After the refrigerator is installed
properly and has cooled for several hours, the
ice maker can produce ice within 24 hours. ]:t
can completely fill an ice bin in about two days.
Ice Production:
What to Expect
How Huch Ice Will a Side Hountad
Ice
Haker Produce in 24 Hours?
For proper dispenser operation, recommended
water supply pressure should fall between 30
A side mounted ice maker will produce 4 to 4.5
psi and 100 psi. Excessive pressure may cause
pounds of ice every 24 hours, depending on
usage conditions. Ice is produced at a rate of 8
water filter to malfunction.
cubes every 75 to 90 minutes.
To prime the water supply system:
1 Begin filling the tank by pressing and
holding a drinking glass against the water
dispenser paddle.
2 Keep the glass in this position until water
comes out of the dispenser. :It may take
about
:[1/z minutes.
3 Continue dispensing water for about four
minutes to flush the system and plumbing
connections of any impurities (stopping to
empty the glass as necessary).
The water dispenser has a built-in device that
shuts off the water flow after three minutes
of continuous use. To reset this shutoff
How Much :Ice Will a Rear Mounted
:Ice
Haker Produce in 24 Hours?
A rear mounted ice maker will produce 3 to 4
pounds of ice every 24 hours, depending on
usage conditions. Ice is produced at a rate of 8
cubes every 75 to 90 minutes.
Using the Ice Maker after
Installation
Before making ice for the first time, be sure
to prime the water supply system. Air in new
plumbing lines can result in two or three empty
ice maker cycles. Furthermore, if the system
is not flushed, the first ice cubes may be
discolored or have an odd flavor.
Your ice maker is shipped from the factory
device, simply release the dispenser paddle,
with the wire signal arm in the ON position
(side mounted) or with the switch turned ON
(rear mounted). To ensure proper function
of your ice maker, hook up water supply
immediately or turn ice maker OFF by lifting
the wire signal arm until it clicks and locks in
the UP position (side mounted) or turn the
On/Off switch to the Off (0) position (rear
mounted). If the ice maker is not turned off
and the water supply is not connected, the
water valve will make a loud chattering noise.
_!!!i_!_!120i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents