Table of Contents
Advertisement
Available languages
Available languages
Before
you
for service
FEN
Your AeroSmart
dryer is capable of diagnosing
its own troubles. If your dryer is displaying
a
message on the display screen and is sounding
a musical series of beeps every 5 seconds, it
has a problem that you may be able to solve using the checklist below. (it's the same sound
AeroSmart dryer makes when you plug it in).
If you are unable to solve the problem from the checklist below call for service.
:: Close the lid and press START/PAUSE.
If the lid is already closed, open the lid and close it again, then press START/PAUSE.
Disconnect
from the power (either by unplugging
the dryer or turning
off the circuit
breaker that supplies it). Wait 10 seconds, reconnect and try turning
it on again.
The machine is unable to close the drum due to clothes interfering
with the
closing mechanism.
Remove any articles that are interfering
with the drum door
and dry these in the next load.
Is your load higher than the top of the lint bucket? Remove some articles and dry
these in the next load.
if your dryer is continually
beeping and a message is displayed
on the screen, a
fault has occurred
which requires repair from a Service Agent.
Pressing the POWER button
once will stop the beeping but will still display the fault code. We
recommend
leaving the machine in this mode as the fault code will enable the service person
to quickly
identify the cause of the problem.
Single beep every second and °°°
1.
Turn your machine
off at the wall.
2.
Wait 1 minute and turn it back on.
3.
Checkyour
machine
is level (refer to installation
instructions
pages 7 - 31).
4.
Remove load and retry.
5.
If the fault re-occurs repeat steps 1 and 2.
If the machine still will not work, call your Fisher & Paykel Dealer or Authorised
Service Agent to
arrange service (refer to page 62).
Advertisement
Table of Contents
