Table of Contents
Advertisement
Available languages
Available languages
Installation
instructions
1-71
l_
Levelling the dryer
Check the dryer is level, and make necessary adjustments
to the front leveling
feet.
The rear l evelling feet a re self a diusting.
Final
installation
check
list
Check that:
,
No plastic or flexible
metal foil is used in the exhaust ducting.
,
Exhaust is rigid ducting
or thick wall flexible
metal ducting.
,
All joints in the ducting
are made with duct tape. It must not be connected
with screws or other
=
Ducting is clean and is connected
to the dryer.
....
,
Inserts are fitted to the two front feet.
}
, Dryer _s _ eve_
across
the f ront.
Additionaly
for electric dryer models only, check:
o
If installation
is 208V, special element kit has been fitted (seepage 21 ).
°
Dryer is plugged or directly wired into an approved fitting
and is properly
grounded.
° Dryer starts, heats,
cools and shuts off.
° Customer
has b een shown how touse t he dryer.
Additionally
for gas dryer models only, check:
o
Dryer isplugged intoan approved fitting a nd isproperly grounded.
o
All fittings
in the gas line are tested for leaks.
o
Exhaust temperature
increases, to confirm
ignition
has occurred.
- If ignition does not occur initially, it may be due to air in the gas lne or low voltage power supply.
- The g as r egulator
valve m ay f a_l toopen _ f t he power supply falls b elow _ 0_ V olts.
- If the gas fails to flow or does not ignite, the dryer will automatically
switch off.
° Customer
has been s hown h ow touse t hedryer.
note: s, dryers have adrum reversal
feature toreduce
clothes tangle. Throughout
the drying
cycle the motor will run for four minutes, then stop and run in the opposite
direction
for forty
seconds before reversing again.
Advertisement
Table of Contents
