Fisher & Paykel AeroSmart DG27C Installation Instructions And User Manual page 23

nsta ation instructions FTfl
Electrical requirements for electric models only
Electric Shock Hazard
Use a new UL approved gO-_amperepower cord or direct wire came°
Use a UL approved strain re_iefo
Disconnect power before making e_ectrica[ connections°
Connect neutra_ wire (white or center wire) to center terminal
On aHfour wire installations remove the grounding _ink and connect the
ground wire to the green ground connecting screw.
Connect remaining 2 supply wires to remaining 2 termina[so
Securely tighten aHe_ectrica[ connections°
Failure to do so can result in death, fire, or electrical shock.
Note: The wiring diagram is [ocated in the contro[ consoJe.
The dryer must be pJugged into or connected to an individual branch circuit, do not use an
extension cor&
The power supply must be 220/240V or 208V, 60 Hz approved alternating current electrical
service.The electrical service requirements can be found on the data [abd that is located on the
splash back. A 30-ampere fuse or circuit breaker is required on each of the lines.
If a power cord is used, the cord must be plugged into a 30-ampere receptacle.
The power cord is NOT provided with U.S.electric mode[ dryers.
This dryer is supplied with the cabinet grounded through the neutral on the terminal block.
If the dryer is to be installed in (1) a new branch circuit installation, (2) a mobile home, (3) a
recreational vehicle, (4) an area where local codes do not permit grounding through the neutral
conductor, the appliance grounding [ink must be removed and a 4-wire power cord/cable or a
separate grounding wire must be used.
Do not reuse a power supply cord/cable from an old dryer. The power cord/cable electric supply
wiring must be retained at the dryer cabinet with a suitable UL listed strain relief.
208V requirements
If your power supply is 208V60 Hz, a new element kit must be fitted by a qualified electrician or
service representative (see Accessories page 7 for kit part number).