Fisher & Paykel OR48DDPWGX User Manual page 30

Freestanding
Hide thumbs Also See for OR48DDPWGX:
Table of Contents

Advertisement

Available languages

Available languages

cleaning
and
maintenance
Before any operation of maintenance
disconnect
the appliance
from
the
electrical mains supply.
De not use steam jet cleaners
because the humidity could
infiltrate
into the appliance making
it dangerous.
GENERAL
RECOMANDATION
/ Important:
Before any operation of cleaning and maintenance
disconnect
the
appliance from the electrical supply.
/
It is advisable to clean when the appliance
is cold and especially for cleaning the
enamelled parts.
,/Avoid
leaving alkaline or acidic substances
(lemon juice, vinegar, etc.) on the sur-
faces.
,/Avoid
using cleaning products with a chlorine or acidic base.
The oven must always be cleaned after every use, using suitable products and keep-
ing in mind that its operation for 30 minutes on the highest temperature
eliminates
most grime reducing it to ashes.
ENAMELLED
PARTS
,/All
the enamelled parts must be cleaned with a sponge and soapy water only or other
non-abrasive
products.
Dry preferably with a chamois leather.
STAINLESS
STEEL ELEMENTS
/ Stainless steel parts must be rinsed with water and dried with a soft and clean
cloth or with a chamois leather.
,." For difficult dirt, use a specific non-abrasive
product
available commercially
or a
little hot vinegar.
/
Note: regular use could cause discolouring
around the burners, because of
the high flame temperature.
INSIDE OF OVEN
,." This must be cleaned regularly.
,." With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy water
or another suitable product.
BURNERS
AND GRIDS
,/These
parts can be removed and cleaned with appropriate
products.
,/After
cleaning, the burners and their flame distributors
must be well dried and cor-
rectly replaced.
,." It is very important to check that the burner flame distributor
and the cap has been
correctly positioned
- failure to do so can cause serious problems.
/ Check that the probe next to each burner is always clean to ensure correct operation
of the safety valves.
,/ In appliances with electric ignition keep the electrode clean so that the sparks always
strike.
/
Note: To avoid damage to the electric
ignition do not use it when the burners
are not in place.
30

Advertisement

Table of Contents
loading

Table of Contents