Fisher & Paykel OR48DDPWGX User Manual page 11

LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE
SAFETY DEVICE (Dual Burners)
In order to light the burner, you must:
Hi
1 - Push and turn the knob in an anti-clockwise direction up to the_ position (maxi-
mum rate of inner crown); push in and hold the knob until the flame has been lit.
The sparks produced by the lighter situated inside the relative burner will light the
flame.
In the event that the local gas supply conditions makes it difficult to light the burner
Hi
in _ position, try again with the knob in _ position.
If there is no mains electrical supply connection, bring a lighted match close to the
burner.
2 - Wait for about ten seconds after the gas burner has been lit before letting go the
knob (safety device activation delay).
3 - Adjust the gas valve to the desired position.
If the burner flame should go out for some reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to the closed position OFF, wait for at least 1
minute and then repeat the lighting procedure.
N.B. When the range is not being used, set the gas knobs to their OFF positions
and also close the gas shut.off valve placed on the main gas supply line.
The range becomes very hot during operation. Keep chi!dren we!! out of reach.
11