Fisher & Paykel OR48DDPWGX User Manual page 21

PROBLEMS ON STARTING AND DURING THE SELF CLEANING
1. Steady
door
The function selector has been turned to the self cleaning position with the oven door
open or not perfectly closed. Or the door has been opened before the cycle has been
started with confirmation from key 3
What to do:
Close the door and repeat previous cycle.
• If after 5 minutes the door has not been closed doorflashes and an audible signal
sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible signal and repeat the
operations to start the cycle.
2. doorwith AUTO flashing
The oven door has been opened after the self cleaning cycle has started (before
locking the door). The self cleaning cycle is zeroed.
What to do:
1. Close the door. p0o00 appears on the electronic programmer display with the letter
P and AUTO flashing.
2. Turn the function selector to OFF and repeat the operations to start the cycle.
• If after 5 minutes the door has not been closed doorflashes and an audible signal
sounds for 30".
What to do:
Close the door, press any programmer key to silence the audible signal and repeat the
operations to start the cycle.
3.
FO.O0 with AUTO flashing
The self cleaning cycle has been stopped and then started again when it was quite a
way through. The message is displayed after about 10 minutes and the self cleaning
cycle is zeroed.
What to do:
1. Put the switch to OFF.
2. Wait for at least 15 minutes.
3. Repeat the operations to start the self cleaning cycle.
4. If after several attempts the message continues contact the Service Centre.
Caution: It is advisable not to stop the self cleaning cycle and then start it again
when it is quite a way through.
21