Fisher & Paykel OR30SDPWGX Installation Instructions Manual

GAS/ELECTRIC
for residential use only
Fisher Paykel
GE
Modol,: OR30S PWGX
iNSTALLATiON iNSTRUCTiONS C
iMPORTANT - PLEASE READ AND FOLLOW
®
US
. Before beginning, please read these instructions completely and carefully.
. Do not remove permanently affixed labels, warnings, or plates from the product. This may
void the warranty.
. Please observe all local and national codes and ordinances.
. Please ensure that this product is properly grounded.
. The electrical plug should always be accessible.
• The installer should leave these instructions with the consumer who should retain
for local inspector's use and for future reference.
Installation must conform with local codes or in the absence of codes, the National Fuel Gas
Code ANSI Z223.1/NFPA 54 - latest edition. Electrical installation must be in accordance with
the National Electrical Code, ANSI/NFPA70 - latest edition and/or local codes.
IN CANADA: installation must be in accordance with the current CAN/CGA-B149.1 National
Gas installation Code or CAN/CGA-B149.2, Propane installation Code and/or local codes.
Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical
Codes Part 1 and/or local codes.
INSTALLATION IN MANUFACTURED (MOBILE) HOME: The installation must conform with
the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 [formerly
the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280)]
or, when such standard is not applicable, the Standard for Manufactured Home Installations,
ANSI/NCSBCS A225.1, or with local codes where applicable.
INSTALLATION IN RECREATIONAL PARK TRAILERS: The installation must conform with
state or other codes or, in the absence of such codes, with the Standard for Recreational
Park Trailers, ANSI Al19.5.
installation of any gas-fired equipment should be made by a licensed plumber. A manual
shut-off valve must be installed in an accessible location in the gas line external to the ap-
pliance for the purpose of turning on or shutting off gas to the appliance (In Massachusetts
such shutoff devices should be approved by the Board of State Examiners of Plumbers &
Gas Fitters).
If an external electrical source is utilized, the appliance, when installed, must be electrically
grounded in accordance with local codes or, in the absence of local codes, with the national
Electrical Code, ANSI/NFPA 70.
i
some moae
parts; This film must be removed before installing!using the appliance:
FOR INSTALLER ONLY
THIS RANGE IS FOR RESIDENTIAL USE ONLY
co
o
_L
O
%-
O
<
co
03
L_
O
O_
L_