Table of Contents
Advertisement
34
olutions to Common Pro
ms
BROWNSTREAKSAND SPECKSON CERAMIC GLASS
COOKTOPSURFACE
. Boitovers have cooked onto surface. Use razor blade scraper to remove soil. See
instructions under General Care & Cleaning.
, Cleaning materials not recommended
for ceramic-glass
cooktop have been used. Use
recommended
cleaners and cleaning method. See Ceramic=Glass
Cooktop
section in
this Owner's Guide.
AREAS OF DISCOLO_TION ON CE_MIC GLASS COOKTOP
SURFACE
• Mineral deposits from water and food. Wet surface with water and sprinkle on a cooktop
cleaning creme. Scrub with a clean damp paper towel until the stain disappears. Wipe
remaining paste away, then apply a small amount of cooktop cleaning creme and polish
with a clean paper towel. Use cookware with clean, dry bottoms. See Ceramic-Glass
Cooktop
section in this Owner's Guide.
APPLIANCE NOT LEVEL
. Place oven rack in center of oven. Place a level on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not level.
Kitchen cabinet misatignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
POORBAKING RESULTS
* Many factors affect baking results. See Baking for hints, causes and corrections.
ENTIREOVEN DOESNOT OPERATE
, When the unit is first plugged in, or when the power supply to the range has been
interrupted, the indicator lights will flash and the control will bee F To stop the lights from
flashing, turn the selector control knob to BAKE and back to OFR The oven cannot be
used until this step is followed.
° Be sure electrical cord is securely connected into the electrical junction box.
o Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact a
qualified servicer.
• Service wiring not complete. Contact a qualified servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug
Replace cord/plug.
• Controls are not set properly. See instructions under Setting Oven Controls
to set the
controls.
• House fuse has blown or circuit breaker has tripped immediately following installation.
House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker
securely.
° House fuse has blown or circuit breaker
has tripped after the oven has been installed
and previously operating. Contact a qualified servicer.
Advertisement
Table of Contents
