Table of Contents
Advertisement
Getting Started
17
BEFORESETTINGOVENCONTROLS
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
!
ll
[]
[]
!
[]
Oven Vent Location
Oven vent
The oven is vented in the backguard
When the oven is on, warm air is re-
leased through the vent. This venting is
necessary for proper air circulation in
the oven and good baking results.
Oven Rack
Support Screw
'Oven Rack Sup-
port Bracket
Installing Oven Rack Sup-
ports
AL WAYS INS TALL 0 VEN
RACK SUPPORT BEFORE
TURNING ON THE 0 VEN
(WHEN THE 0 VEN IS COOL). To remove the oven rack
supports
for a self-clean cycle, remove the screw located
over the rack support on each side, pull up the support from
the oven rack support brackets to disengage supports from the
oven. If the rack supports are not removed, the self-clean cycle
won't start. Always remove the left side support first. To install
oven rack supports
insert the rack supports into the rack sup-
port brackets on the oven side as shown and put back screws
at their original location.
Removing
and Replacing Oven
Racks
ALWAYS ARRANGE 0 VEN
RACKS WHEN THE OVEN tS COOL
(PRIOR TO OPERATING THE 0 VEN).
Always use oven mitts when using the
oven.
To remove an oven rack, pull the rack
forward. Lift up the rack off the oven
rack slider. To replace an oven rack,
place the rack on the slider into the 4
pinholes located at the 4 corners of the
rack.
Installed
on sliders
To remove
from
sliders
Pull oven rack forward
and
lift it up of the oven rack
slider.
To place on
sliders
Removing
Non-Sliding
Oven Racks
Simply pull the rack and slightly tilt it upward when the rack hits its stop position.
Replacing
Non-Sliding
Oven Racks
Insert the rack into the oven rack supports by inserting the rack openings into the rack sup-
ports= Be sure the rack is at the same position on each oven rack support on both sides.
?
?
Int:th tehea° P es_ui;;Sr t
_
Always arrange the oven racks when the oven is cool (prior to operating the oven). Always use
oven mitts when using the oven.
Advertisement
Table of Contents
