Troubleshooting; Electronics Troubleshooting - Craftsman 113.198251 Operator's Manual

u_ ..... i .......... i,,,i i., iii1,, II"MII'
Troubleshooting
i , , p q ,,, ,p, , qp I ...... , q, IllU q ....
WARNING: To avoid injury turn power switch off and remove plugfrom power
source outlet before troubleshooting.
Electronics
Problem Probable Cause What to Do
No display when On/Off
button is pressed,
Battery not installed correctly. Adjust battery position in com-
partment.
Battery contacts dirty. Clean battery contacts.
Battery dead. Replace battery with 6V, size J,
alkaline battery.
Indicator display failure, Contact Sears. Have electronics
checked by qualified technician.
Display shows
Normal display when battery is No action required.
first installed in unit.
ELE =
Reference points not set for
desired display.
Follow procedure for setting zero
reference points in the Setting
Electronic Display section,
Poor battery contact to in- Clean battery contacts. Adjust
dicator display leads causing in- battery position in compartment.
termittent power to display.
Indicator' display failure.
Contact Sears. Have electronics
checked by qualified technician.
Display dim.
Low battery voltage. Replace battery with 6V, size J,
alkaline battery.
Saw very cold.
Allow saw to warm to above
32 .
Display dark.
Saw very warm,
Allow saw to cool to below 120°F.
Display blains after a few
minutes.
Normal.
Press On/Off button. Display
should return.
Display blanks when
moving carriage, then
re-appears when motion
stops.
Normal. Sometimes indicator
will not display while blade
position is changing rapidly.
No action required.
78