Assembling Steel Legs - Craftsman 113.242720 Owner's Manual

ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model 113.242720.
From among the loose parts, find the following Hardware:
24 Truss Head Screws, 1/4 - 20 x 5/8 in. long (top of
screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia. of
hole 1/4 in.)
24 Hex Nuts, 1/4 - 20 (approx. dia. of hole 1/4 in.)
8 Hex Nuts, 1/2 - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legs as shown...
1. Insert the Truss Head Screws through the holes in the
legs, then through the holes in the stiffeners. MAKE
SURE THE SCREWS GO THROUGH THEHOLES IN
THE SIDE STIFFENERS MARKED "X".
2. Install Iockwashers and screw on the nuts but do not
tighten until completely assembled.
3. Install leveling feet.
END
SCREWS THROUGH
HOLES MARKED "X"
STIFFENER
IN. HEX NUTS
_.,_......__.------ LEVELING FOOT
MOUNTING SAW
1. From the loose parts find the four 1/4-20 x 5/8 in.
Truss Head Screws, 17/64 x 5/8 x 1/16 Flat Washers,
1/4 in. Lockwashers and 1/4-20 Hex Nuts.
2. Position legs as shown and line up holes in stiffeners
with holes in saw base.
NOTE: At front of saw you will see four sets of holes.
Insert bolts through holes closest to front of saw . . .
these holes are 9-1/4" apart.
Attach legs using the screws, washers, Iockwashers
and nuts.., tighten the nuts.
3. Place saw in upright position.
FRONT
REAR
If you mount the saw on any other bench, make sure that
there is an opening in the top of the bench the same size as
the opening in the bottom of the saw so that the sawdust
can drop through. Recommended working height is 33 to
37 in. from the top of the saw table to the floor.
OPENING
NOTE: All dimensions in inches.
10
1//2
1/4
FRONT OF SAW
4 HOLES
7//16 DIA.