2.
Cut and remove the polyester bands.
3.
Remove the nails attaching the carton to the pallet.
4.
Remove the plastic carton fasteners.
5.
Remove the carton.
Steps 6 through 8 refer to
4. Accessory boxes
6. Corner pads
8. Poly bag
Figure 19 Unpacking the disk array
.
6.
Remove the accessory boxes, ramp, and corner pads.
7.
Using a 6 mm hex and 19 mm wrench, remove the adapter plates that anchor the rack to the
pallet.
8.
Remove the poly bag covering the rack.
9.
Following the instructions provided on the wooden ramp, attach the ramp to the pallet and roll
the rack onto the floor.
Figure
19.
5. Ramp
7. Pallet adapter plates
XP24000/XP20000 Disk Array Site Preparation Guide
65