Brocade Communications Systems StoreFabric SN6500B Documentation Update page 70

10
Chapter 5, Removal and Replacement Procedures
3. Run the supportsave command on the active CP to capture all settings.
4. Contact Brocade Technical Support for a replacement WWN card. Technical Support will
Under the subheading "Removing the WWN card and WWN bezel (logo plate)" on page 69, replace
the steps with the following:
When the replacement WWN card has been received, complete the following steps to remove the
bezel and faulted WWN card.
ATTENTION
Follow ESD precautions (see "ESD Precautions" in your chassis manual).
1. Open a Telnet session to the chassis and log in to the active CP as admin. The default
2. Verify that you are logged into the active CP. Run the haShow command to determine the active
3. Run the supportsave command on the active CP to capture all settings. If any problems occur
4. Remove the screws from the WWN bezel. Pull the bezel away from chassis and set it aside. The
5. Use a Phillips screwdriver to unscrew the two screws that secure the WWN card to the chassis.
6. Disconnect the WWN cable by depressing the cable connector latch and pulling the connector
7.
Under the subheading "Replacing the WWN bezel (logo plate) and WWN card" on page 70, delete
steps 3 and 4.
58
require the supportsave data collected in the previous step so that a replacement can be
programmed prior to shipping to your location.
DO NOT execute the frureplace command. The command will no longer be functional beginning
with the release of Fabric OS 7.0.0c, but users with earlier versions of the Fabric OS should
also NOT run the command.
password is "password".
CP.
during the replacement, the information will be important for solving the problem.
WWN cards are visible.
Hold the card by the edges and remove it.
from the WWN module.
Set the WWN card on a static-free surface, such as a grounding pad.
Fabric OS Documentation Updates
53-1002063-09