Brocade Communications Systems StoreFabric SN6500B Documentation Update page 45

To configure Edge hold time on an enabled switch:
portLoopBackTest
Augment the note section of the portLoopBackTest help pages as follows:
This diagnostic cannot be run on an operational switch. You must disable the switch using the
chassisDisable command before you can run this test. After the test completes, re-enable the switch
using the chassisEnable command.
Do NOT use the switchDisable command followed by manually shutting down the ports before running
the test. This will not work, because executing switchEnable, after the test completes, will leave the
ports in the same state as before. The only way to bring the ports down before running the test and back
up after the test completes is by using the chassisDisable command followed by the chassisEnable
command
turboRamTest
:Augment the note section of the turboRamTest help pages as follows:
This diagnostic cannot be run on an operational switch. You must disable the switch using the
chassisDisable command before you can run this test. After the test completes, re-enable the switch
using the chassisEnable command.
portLedTest
:Augment the note section of the portLedtestTest help pages as follows:
This diagnostic cannot be run on an operational switch. You must disable the switch using the
chassisDisable command before you can run this test. After the test completes, re-enable the switch
using the chassisEnable command.
Fabric OS Documentation Updates
53-1002063-09
Switch:admin> configure
Not all options will be available on an enabled switch.
To disable the switch, use the "switchDisable" command.
Configure...
Fabric parameters (yes, y, no, n): [no] yes
Configure edge hold time (yes, y, no, n): [no] yes
Edge hold time: (100..500) [220]
System services (yes, y, no, n): [no]
ssl attributes (yes, y, no, n): [no]
rpcd attributes (yes, y, no, n): [no]
webtools attributes (yes, y, no, n): [no]
System (yes, y, no, n): [no]
portLoopBackTest
5
33