Chapter 9, Configuring Qos Using The Cee Cli - Brocade Communications Systems StoreFabric SN6500B Documentation Update

Chapter 9, Configuring QoS using the CEE CLI

Under the heading of "Creating a CEE map" on page 109, add the following note:
Under the heading of "Creating a CEE map" on page 109, delete the example under step 2.
Under the heading of "Defining a priority group table" on page 109, add the following note:
Under the heading of "Defining a priority group table" on page 109, delete the example under step
4.
Under the heading of "Defining a priority-table map" on page 110, add the following note:
Under the heading of "Defining a priority-table map" on page 110, delete the example under step 3.
Under the heading of "Applying a CEE provisioning map to an interface" on page 112, delete the
example under step 3.
Fabric OS Documentation Updates
53-1002063-09
NOTE
The name used in the cee-map command must begin with a letter, and can consist of letters,
digits, hyphens, and underscore characters. Spaces are prohibited. Special characters are not
supported, and cause the name to truncate.
NOTE
The name used in the cee-map command must begin with a letter, and can consist of letters,
digits, hyphens, and underscore characters. Spaces are prohibited. Special characters are not
supported, and cause the name to truncate.
NOTE
The name used in the cee-map command must begin with a letter, and can consist of letters,
digits, hyphens, and underscore characters. Spaces are prohibited. Special characters are not
supported, and cause the name to truncate.
Documentation updates for Fabric OS v6.4.1
2
5