Reference Information; Configuring The Access Point's Wireless Lan Settings Manually - Canon PIXMA MX340 Network Setup Troubleshooting

Reference Information

Configuring the Access Point's Wireless LAN Settings Manually

Action
Enter the access point name/network name (SSID) and security setting (WEP, WPA,
etc.) directly.
Follow the procedure below.
1
Perform to in "Install the Software (2)" on page 27 in the printed manual:
Getting Started.
• If the Detected Access Points List screen is
displayed, go to .
2
When the Confirm Connection Access
Point screen appears, click No (A).
• The Detected Access Points List screen is
displayed.
3
Click Manual Setup (B).
• The Manual Setup screen is displayed.
4
Enter the access point name/network name
(SSID) in SSID (C).
5
Select the security protocol for the access
point in Encryption Method (D), then click
Configuration (E).
• Go to either of the following steps according
to the selected Encryption Method (security
protocol).
Disable Go to
WEP Go to
WPA/WPA2 Go to
A
B
C
D
on page 8.
.
on page 8.
6-A
WEP
1
Enter the network key in WEP Key (F).
• Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
2
Select Key Length (G).
• When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.
• When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
bit.
3
Select Key Format (H).
• Select Characters when the network key is 5 or 13 characters.
Select Hexadecimal when it is 10 or 26 characters (digits).
4
Select Key ID (I).
• When using AirPort, select 1 in the screen.
Selecting other key numbers will disable the connection between the machine and
AirPort.
5
Select Authentication (J), then click OK (K).
Go to
E
WPA/WPA2
K
on page 8.
(P.8)
Disable (P.8)
F
G
H
I
J