Reference Information
Entering the Access Point's Wireless LAN Settings Directly on the
Machine
Action
Enter the access point name/network name (SSID) and security setting (WEP, WPA,
etc.) on the machine directly.
Follow the procedure below.
1
Use the Easy-Scroll Wheel to select Settings, then
press the OK button.
2
Select Wireless LAN setup, then press the OK button.
3
Select Yes, then press the OK button.
•
When wireless connection is enabled, the Wi-Fi lamp lights
blue.
4
Select Easy settings, then press the OK button.
5
Select Directly enter the access point name, then
press the OK button.
•
If you are living in an apartment, nearby access points in use
may be detected.
6
Enter the access point name/network name (SSID)
using the Easy-Scroll Wheel, then press the OK button.
Use the Easy-Scroll Wheel to select the character. Use the ]
button to move the cursor to the right.
•
Enter the same access point name/network name (SSID) as
that of the access point on the machine.
•
For details on how to check the access point name/network name (SSID), refer to the manual
supplied with the access point or contact its manufacturer.
•
Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
7
Select a security protocol for the access point, then
press the OK button.
•
Go to either of the following steps according to the selected
security protocol.
Disable
WEP
WPA/WPA2
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select WEP (64 bit).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select WEP (128
bit) or WPA2-PSK (AES).