Installing The Optical Drive - Dell PowerEdge T620 Owner's Manual

Figure 20. Removing and Installing the Optical Drive
1. optical drive
2. screw
3. release latch

Installing The Optical Drive

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. If installed, remove the front bezel.
2. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
3. Open the system.
4. Align the optical drive with the optical drive bay.
5. Slide the optical drive into the slot until the latch snaps into place.
6. Connect the power/data cable to the back of the drive.
7. Route the power/data cable along the inside left wall of the chassis.
8. Connect the power/data cable to the connectors on the system board.
9. Close the system.
10. If applicable, install the front bezel.
11. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
55