Hard-Drive Backplane - Dell PowerEdge T620 Owner's Manual

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2. Lay the system on its side.
3. Open the system.
4. Remove the cooling shroud.
5. Locate the battery socket. For more information, see System Board Connectors.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
6. To remove the battery, support the battery connector by pressing down firmly on the positive side of the connector.
Figure 37. Removing and Installing the System Battery
1. positive side of battery connector
2. system battery
7. Lift the battery out of the securing tabs at the negative side of the connector.
8. To install a new system battery, support the battery connector by pressing down firmly on the positive side of the
connector.
9. Hold the battery with the "+" facing up and slide it under the securing tabs at the positive side of the connector.
10. Press the battery straight down into the connector until it snaps into place.
11. Install the cooling shroud.
12. Close the system.
13. If applicable, place the system upright and on its feet on a flat, stable surface.
14. Reconnect the system to the electrical outlet and turn the system on, including any attached peripherals.
15. Enter the System Setup to confirm that the battery is operating properly.
16. Enter the correct time and date in the System Setup Time and Date fields.
17. Exit the System Setup.

Hard-Drive Backplane

Depending on your configuration, your system supports the following:
• 3.5 inch x8 SAS/SATA backplane or
82