Dell PowerEdge T620 Owner's Manual page 18

Item Indicator, Button, or
Connector
4 System identification button
5 System identification
connector
6 iDRAC Enterprise port
7 Power supply (PSU1)
8 USB connectors (6)
9 Video connector
10 Serial connector
11 Power supply (PSU2)
12 PCIe expansion card slots
full height (3) (processor 2)
18
Icon Description
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the LCD panel on
the front and the system status indicator on the back flash
until one of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press and
hold the system ID button for more than five seconds to
enter the BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup), press
and hold for more than 15 seconds.
Allows you to connect the optional system status indicator
assembly through the optional cable management arm.
Dedicated management port.
NOTE: The port is available for use only if the iDRAC
Enterprise license is installed on your system.
AC 495 W, 750 W, or 1100 W
or
DC 1100 W (when available)
Allows you to connect USB devices to the system. The
ports are USB 2.0-compliant.
Allows you to connect a VGA display to the system.
Allows you to connect a serial device to the system.
AC 495 W, 750 W, or 1100 W
or
DC 1100 W (when available)
Connects up to three full-height PCI Express expansion
cards.