Figure 15. Removing the optical drive
Next steps
Replace the optical drive.
Installing the optical drive
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align and slide the optical drive into the optical drive slot on the system until it latches.
2. Connect the power cable and signal cable to the optical drive.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
27