Dell PowerEdge T300 Series Hardware Owner's Manual page 31

Table 1-6. System Messages (continued)
Message
Alert! Unsupported
memory, incomplete
sets, or unmatched
sets. The following
memory is disabled:
Attempting to
update Remote
Configuration.
Please wait...
BIOS Update Attempt
Failed!
Caution! NVRAM_CLR
jumper is installed
on system board.
Decreasing
available memory
Diskette drive 0
seek failure.
Diskette read
failure.
Causes
Unsupported DIMMs,
mismatched DIMMs, or
unmatched DIMMs have
been detected. If more
than one DIMM is
present, DIMMs must be
installed in matching
pairs.
Remote Configuration
request has been detected
and is being processed.
Remote BIOS update
attempt failed.
NVRAM_CLR jumper is
installed. CMOS has been
cleared.
Faulty or improperly
installed memory
modules.
Faulty or improperly
inserted diskette,
incorrect configuration
settings in the System
Setup program, or loose
diskette/tape drive
interface cable, or loose
power cable. Replace the
diskette.
Faulty diskette, faulty or
improperly connected
diskette/tape drive
interface cable, or loose
power cable.
Corrective Actions
For memory configuration
information, see "Memory
Module Installation
Guidelines" on page 110. If
the problem persists, see
"Troubleshooting System
Memory" on page 146.
Wait until the process is
complete.
Retry the BIOS update. If
the problem persists, see
"Getting Help" on page 175.
Remove the NVRAM_CLR
jumper. See Figure 6-1 for
jumper location.
See "Troubleshooting System
Memory" on page 146.
See "Troubleshooting a
Diskette Drive" on page 149.
See "Troubleshooting a
Diskette Drive" on page 149.
About Your System
31