Sas Backplane Board Connectors - Dell PowerEdge T300 Series Hardware Owner's Manual

Table 6-2. System Board Jumper Settings
Jumper Setting
NVRAM_CLR
Pins 3-5 (default)
Pins 1-3
PWRD_EN
Pins 2-4 (default)
Pins 4-6

SAS Backplane Board Connectors

CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
The SAS backplane is present in systems that have a front-loading hot-plug
hard drive bay (when available). Figure 6-2 shows the locations of the SAS
backplane connectors.
Description
The configuration settings in NVRAM are
retained at next system boot.
The configuration settings are cleared at the next
system boot. (If the configuration settings
become corrupted to the point where the system
will not boot, install the jumper and boot the
system. Remove the jumper before restoring the
configuration information.)
The password feature is enabled.
The password feature is disabled.
Jumpers and Connectors
171