Internal Usb Memory Key Connector; Installing The Optional Internal Usb Memory Key - Dell PowerEdge T300 Series Hardware Owner's Manual

8 Close the expansion card latch to secure the card in the system (see
Figure 3-20).
NOTICE:
damage the surrounding system board components.
9 Connect the ribbon cable to the RAC_CONN connector on the system
board and then to connector 2 on the RAC card (see Figure 3-22).
10 Close the expansion card cover (see Figure 3-7).
11 Replace the system cover (see "Installing the System Cover" on page 67).
12 Reattach any peripherals you disconnected, then connect the system to
the electrical outlet.
13 Turn on the system and attached peripherals.
14 Install any device drivers required for the card.

Internal USB Memory Key Connector

The system provides an internal USB connector located on the system board
for use with an optional USB flash memory key. The USB memory key can be
used as a boot device, security key, or mass storage device. To use the internal
USB connector, the Internal USB Port option must be enabled in the
Integrated Devices screen of the System Setup program.
To boot from the USB memory key, you must configure the USB memory key
with a boot image and then specify the USB memory key in the boot
sequence in the System Setup program (see "System Setup Options" on
page 43). For information on creating a bootable file on the USB memory key,
see the user documentation that accompanied the USB memory key.

Installing the Optional Internal USB Memory Key

CAUTION:
cover and access any components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer, and protecting against
electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Remove the system cover (see "Removing the System Cover" on page 66).
104
Installing System Components
When attaching the cable to the system board, ensure that you do not
Only trained service technicians are authorized to remove the system