Assembly - Image 10.0 User Manual

ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-
driver , adjustable wrench _ , wire cutters __ , and needlenose
pliers _.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
To identify small parts during assembly, use the part identification drawings below.
1 1/2" Screw (79)-4
<_\\\\\\\\\D (_
3/4" Screw (68)-2
4" Bolt (89)-4
3/4" Tek Screw
(101)-5
Silver Screw
(107)-1
Wheel Bolt (86)-2
3" Bolt (47)-4
Washer (29)-8
Wheel Nut (15)-2
1. Make sure that the power cord is not plugged in.
With the help of a second person, carefully tip the
treadmill onto its left side. Partially fold the Frame (12) so
that the treadmill will be more stable. Do not fully fold
the treadmill until it is completely assembled.
Attach two Base Pads (97) to the bottom of the Base (82)
with two 3/4" Tek Screws (101). Attach a Wheel (95) to
the outside of the Base with a Wheel Bolt (86) and a
Wheel Nut (15).
6
1
._----101 86
_97
,. 15
"