Table of Contents
Advertisement
HOW TO LOWER THE TREADMILL FOR USE
,
Hold the upper end of the treadmill with your right hand
as shown. Using your left hand, pull the latch knob to the
left and hold it. Pivot the treadmill down until the frame is
past the pin on the latch knob. Slowly release the latch
knob.
__
Latch
Open
Knob
,
Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. Do not drop the treadmill
frame
to the floor. CAUTION: To decrease the possibility
of
injury, bend your legs and keep your back straight.
2
21
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 10.0 and is the answer not in the manual?
Questions and answers
Powers on but displays multiple 8s and belt died not move
If the Image 10.0 treadmill powers on but displays multiple 8s and the belt does not move, it likely indicates that the console is in a diagnostic or reset mode, or that it is not receiving proper input from internal components. Try the following steps:
1. Remove the key and unplug the power cord.
2. Reinsert the key fully into the console.
3. If the treadmill still does not run, check the alignment and gap of the Reed Switch and Magnet as described in the speed display troubleshooting section.
4. If the problem persists, contact Customer Service.
This answer is automatically generated