Table of Contents
Advertisement
The decals shown have been placed on your treadmill. If a decal is missing, or if
it is not legible, please call our Customer Service Department, toll-free, to order
a free replacement decal (see the front cover of this manual). Apply the decal in
the location shown. Note: The decals are not all shown at actual size.
ACAUTION
KEEP HANDSAND FEETAWAY
FROM THIS AREA WHILE THE
TREADMILL IS IN OPERATION.
4
Protect yourself and
others from risk of serious
injury. Read the user's
manual and :
• Stand only on the
side rails when
starting or stopping
treadmill.
• Change speed in
small increments.
• Hold handrails to
prevent
falling, and
always wear the
safety clip while
operating
treadmill.
• Stop if you feel faint,
dizzy, or short of
breath.
• Fully engage storage
latch before tread-
mill is moved or
stored.
• Reduce incline to its
lowest level before
folding treadmill into
storage position.
notin
use.
• Keep clothing,
fingers, and hair
away from moving
belt.
• Never try to adjust
or fix the belt while
it is moving.
• Always wear
athletic
shoes while
operating
treadmill.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 10.0 and is the answer not in the manual?
Questions and answers
Powers on but displays multiple 8s and belt died not move
If the Image 10.0 treadmill powers on but displays multiple 8s and the belt does not move, it likely indicates that the console is in a diagnostic or reset mode, or that it is not receiving proper input from internal components. Try the following steps:
1. Remove the key and unplug the power cord.
2. Reinsert the key fully into the console.
3. If the treadmill still does not run, check the alignment and gap of the Reed Switch and Magnet as described in the speed display troubleshooting section.
4. If the problem persists, contact Customer Service.
This answer is automatically generated