Do you have a question about the 10.0 and is the answer not in the manual?
Questions and answers
Nicole Prisby
April 7, 2025
Powers on but displays multiple 8s and belt died not move
1 comments:
Mr. Anderson
April 9, 2025
If the Image 10.0 treadmill powers on but displays multiple 8s and the belt does not move, it likely indicates that the console is in a diagnostic or reset mode, or that it is not receiving proper input from internal components. Try the following steps:
1. Remove the key and unplug the power cord. 2. Reinsert the key fully into the console. 3. If the treadmill still does not run, check the alignment and gap of the Reed Switch and Magnet as described in the speed display troubleshooting section. 4. If the problem persists, contact Customer Service.
Need help?
Do you have a question about the 10.0 and is the answer not in the manual?
Questions and answers
Powers on but displays multiple 8s and belt died not move
If the Image 10.0 treadmill powers on but displays multiple 8s and the belt does not move, it likely indicates that the console is in a diagnostic or reset mode, or that it is not receiving proper input from internal components. Try the following steps:
1. Remove the key and unplug the power cord.
2. Reinsert the key fully into the console.
3. If the treadmill still does not run, check the alignment and gap of the Reed Switch and Magnet as described in the speed display troubleshooting section.
4. If the problem persists, contact Customer Service.
This answer is automatically generated