Toll Saver - HP 1050 series User Manual

Remote Access
Table
4-1 Remote access commands
........ , ',' "" ,,,1_,,_ .......... _ ........ ,"' ,',',....
Code Function
#3 Skips
tO the next message L
#4 Allows you to change the GreetingL After entering thecommand, speak into the
handsel Press # when you are done°Thedevice will play the Greeting for you so
you can confirm the recording°
#5 Playsback all the messages (old and new) one by one. After each messageis
played, press * to hear the next message,.
#6 Replaysthe currentmessage
#7 Erasesthe current messageand plays the next one_
#8 Turnsthe messagecenter on and off_When you turn it on, the Greeting is played,
#9 Erasesall the messages** Thedevice witl beep twice when it's done.
• Playsthe next messageif enteredlhe #5 or #2 command,.
Tol! Saver
Toll Saver allows you to tell whether or not there are new messages before the message
center answers the phone, This feature allows you to hang up before incurring phone
charges_
When Toll Saver is on and there are no new messages, the HP Fax adds two rings to the
Rings to Answer setting. For example, if Rings to Answer is set to 4, the device will ring 6
times before answering if there are no new messages_ (See Set rings to answer on page
27_)
Follow these instructions to turn Toll Saver on and off°
1. PressMenu repeatedly until SET OP TAM displays and press Start/Enter,
2. Press 4 1.until
Toll Saver
displays and press Start/Enter_
3o Press _1 I_ until on displays and press Start/Enter.
Digital messagecenter (HP 1050 Fax only) 40