Turning On And Offthe Camera - Nikon COOLPIX P100 User Manual

Turning On and Off the Camera
Remove tile lens cap before turning on tile camera. Press
the power switch to turn on the camera. The power on
lamp(green) will light for a moment and the monitorwill
turn on.
Pressthe power switch again to turn offthe camera.
When the power is turned off, both the power or] lamp
and monitor turn off.
• \A!hen the camera is off, holding down the [] button will turn the camera or] in
playback mode ([_[_32).
[] Lens Error
If Lens error. (If the lens cap is attached, turn the camera off, remove the lens cap, and turn
the camera on.) is displayed, check that the lens cap has been removed and turn the camera on
again.
[] Standby Mode (Auto Power Off)
If no operations are performed, the monitor turns off automatically, the camera enters standby mode
and the power on lamp blinks, If no operations are performed for another three minutes, the camera
will turn off automatically,
• During shooting or playback, if no operations are performed for about a minute (default setting),
the camera enters standby mode.
• if the monitor is off in standby mode (when the power on lamp blinks), perform the following
operations to turn on the monitor,
Press the power switch, the shutter release button or the [] button,
Rotate the mode dial,
• The time that elapses before the camera enters standby mode can be changed from the Auto off
(_165) in the setup menu (_152).
21