Panasonic Lumix DMC-GH2 Operating Instructions Manual page 83

Others
• It has failed to read or write data.
Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
Insert a different card.
If you want to delete some pictures, format the card after saving necessary data on a PC
etc. (P62)
Insert a different card.
• Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures in
[AVCHD].
Also, use a card with SD Speed Class with "Class 6" or higher when recording motion pictures
in [MOTION JPEG].
• In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P62).
• Depending on the type of the card, motion picture recording may stop in the middle.
• The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format (P62) the card in this unit.
• A folder cannot be created because there are no remaining folder numbers that can be used.
(P165)
Format the card after saving necessary data on a PC etc. (P62) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P62)
• The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete this message at once.
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P60)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P163, 166)
• The battery cannot be recognized by the camera.
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
• The battery cannot be recognized as its terminal is dirty.
Remove any dirt etc. from the terminal.
• When attaching the stereo microphone (DMW-MS1 ; optional), check the battery status and
make sure the power is on before use. (P172)
VQT3A36 183