Panasonic Lumix DMC-GH2 Operating Instructions Manual page 51

Playback/Editing
• The number of prints can be set from 0 to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the print settings with other equipment. In this case, cancel all the
settings, and reset the settings.
• If the file is not based on the DCF standard, the print setting cannot be set.
• The [PRINT SET] feature is disabled for motion pictures and pictures taken with the [QUALITY]
set to [RAW].
You can set protection for pictures you do not want to be deleted by mistake.
• For details about the icon display during Burst Picture Group playback, refer to P138.
1 Select [PROTECT] on the [PLAYBACK] Mode menu. (P55)
2 Press i,/T to select the item and then press [MENU/SET].
• When [SINGLE IN BURST GROUP] or
[MULTI IN BURST GROUP] is selected, press ,&IVI411_ to
select Burst Picture Group, and press [MENU/SET] to proceed to
step 3.
• When [CANCEL] is selected, see "Canceling all the [PROTECT]
settings".
3 [SINGLE] [MULTI]
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
• Repeat these steps for each picture.
• The settings are canceled when
[MENU/SET] is pressed again.
• Press [@] to return to the menu screen.
Press ,_!1_ to select Press •!V!_!ll,- to
the picture, select the pictures.
• Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press • to select [YES] and then press [MENU/SET].
• If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
• The [PROTECT] feature is only designed to work with this camera.
• Even if you protect pictures on a card, they will be deleted if the card is formatted.
• Even if you do not protect pictures on a card, they cannot be deleted when the card's
Write-Protect switch is set to [LOCK].
VQT3A36 1 51