Panasonic Lumix DMC-GH2 Operating Instructions Manual page 32

Recording
This will set the operation of the [@] button when displaying the
3review screen.
[OFF]:
[PREVIEW HOLD]
toni:
Preview screen is displayed only when the [@] is
pressed.
It will return to previous screen when [@] is released.
Preview screen is displayed even after the [@] is
released after pressing. (P95)
It will return to previous screen when [@] is pressed
again.
[CONSTANT PREVIEW] [OFF]/[ON] 1
• Refer to P94 for details.
Select whether or not to display the exposure meter when the mode dial is
[EXPO.METER] .... switched to [_/[]/_]/[_ etc.
[OFF]/[ON]
• Set to [ON] to display the [EXPO.METER] when correcting exposure,
performing Program Shift, setting aperture, and setting shutter speed.
• Unsuitable areas of the range are displayed in red.
• When [EXPO.METER] is not displayed, switch the display information
for LCD monitor/viewfinder by pressing [DISPLAY]. (P63)
• The [EXPO.METER] disappears after approximately
4 seconds if no operation is performed.
Change the method of Exposure Compensation setting switching
when the mode dial is set to _]_, [], [] and [_.
SW,TCH BY PRESS.NG T.E REAR D.A.]:
Press the rear dial to switch between Exposure Compensation,
Program Shift, aperture setting, and shutter speed setting.
[SWITCH BY PRESSING THE LVF/LCB BUTTON]:
Press [LVF/LCD] to switch between Exposure Compensation,
Program Shift, aperture setting, and shutter speed setting.
Setting items for each [REC] Mode
Program Shift Exposure Compensation
[] Aperture Exposure Compensation
[] Shutter speed Exposure Compensation
[] Shutter speed Aperture
• You cannot switch between LCD monitor and viewfinder by pressing [LVF/LCD] when it is set to
[SWITCH BY PRESSING THE LVF/LCD BUTTON].
• [EXPO. SETTINGS] is disabled when you set [AUTO SWITCH] in [LVF/LCD SWITCH] to [OFF].
132 VQT3A36