Using Tile Pc Settings Leature; Setting Tile Pc Audio - Toshiba 40G300U Owner's Manual

5 Press _ to select 0U. When the control panel
is locked and any button oll the control panel
(except P0WFR) is pressed, the message "NOT
AVAILABLE" appears.
Note: The screen is disrupted momentarily
when adjusting the PC settings. This is not a
sign of malfunction.
To unlock the control panel:
Select 0If in step 5 above, or press and hold the
V0L[JNF - button on the TV control panel for about
10 seconds until the volume icon appears.
Using the PC settings feature
You can view an hnage from a PC on the TV screen.
When a PC is connected to the TV's PC IN
terminal, you can use the PC Settings feature to
make adjustments to the image. [f the edges of the
picture are cut off, readjust the
Horizontal Position
and Vertical Position. If the picture is affected by
interference, readjust the C[0ck Phase and SalllpJiug
Clock.
To adjust the PC settings:
1
Repeatedly press (_) to select PC input mode
(_1_> "Selecting the video input source to view"
page 35).
MENU Press O and open the Setup menu.
3 Highlight PC Settiugs and press @.
Note: lf a PC is not connected or there is no
pc input signal, this feature will be grayed
out in the Setup menu.
4 Press A or V to highlight the item you want to
adjust.
5 Press 4 or _ to make the appropriate
adjustlllents.
Horizontal Moves the picture left/right.
Position The adjustment range is within _+50 from
center.'i_
Vertical Moves the picture upMown.
The adjustment range is within _+10 from
Position center.*
Helps to reduce noise and sharpen the
Clock picture.
Phase The adjustment range is within _+16 from
center.*
Helps to reduce noise and minimize
Sampling periodic vertical stripes on the screen.
Clock The adjustment range is within _+10 from
centel:'i_
Auto Highlight this item then press @
Adjust to get an optimum adjustment
automatically.
* The default settings may vary depending on
the input signal format.
Setting the PCAudio
This function allows you to output
or mute the sound
from your PC when connecting using the PC IN
terminal and an analog RGB cable. (_1_> page 18)
To set the PC Audio:
MENU Press O and open
the $OUUd menu.
Highlight Audio
Setup
and press @.
3 Press A or V to select PC Audio and then press
4 or _ to select N0 or
Yes.
Yes:When viewing the PC input, the audio from
the PC Audio input can be heard.
NO:When viewing the PC input, there will be no
audio.
Note: Because the PC and HDMI- 7 inputs
share the same set of analog audio inputs,
the PC Audio menu setting influences the
HDMI 1 Audio menu setting. If PC Audio
(confim_('d)
5O