Programming Tile Remote Control To Control Your Other De,Ices - Toshiba 40G300U Owner's Manual

REC MENU*
SLOW REW*
SLOW FWD*
Angle*
Sub title*
Audio*
Eject*
Record (2
click)
--- DVD Angle
--- DVD Sub title
--- DVD Audio
--- DVD Eject
Programming the remotecontrol
to controlyour other devices
Your Toshiba TV
remote control is preprogrammed
to operate most Toshiba devices. To program your
TV remote control to operate a non-Toshiba device
(or a Toshiba device that it is not preprogrammed to
operate), follow the steps below. For details on using
the remote control to operate the device, see page 23.
1 In the remote control code table (v,r page 26), find the
code for your device. If more than one code is listed,
try each one separately until you find one that works.
2
Set the NODESELECT s witchto the typeof device you are
programming theremote control to operate-- CABLE/
SAT(for a cable converterbox or satellite receiver),AUX
1 (for a VCU or TV/VCR combo), or AUX 2 (for a DVD
player or HTIB [hometheater in a boxl).
• RECALL
3 Whileholdlng down O , press the Channel Number
buttons to enter the 3-digit code for your device.
4 To test the code, turn on the device, point the remote
control at it, and press po_R. See notes below.
, If the correct code was entered, the device will
turn off.
, If the device does not respond, repeat steps 1-4
using another code.
, If the device does not respond to another code,
you will need to use the remote control that came
with the device.
5 Remember to set the NODESELECT switchback to
"TV" to control the TV.
For future reference, write down the code(s) you used:
Note:
• In addition to POWER,confirm that all necessary
keys on the TVremote control operate your device.
If some keys are not operational, repeat the device
code setup using another code (ff other codes
are listed for your device). If, after trying all listed
codes, the necessary keys do not operate your
device, use the device's on_Tinal r emote control.
Every time you change the batteries, you will need
to reprogram the remote control.
Some newer VCRs respond to either of two codes.
These VCRs have a switch labeled "VCR1/VCR2."
If your VCR has this kind of switch and does not
respond to the codes for your VCR brand, set the
switch to the other position ("VCR1" or "VCR2")
and reprogram the remote control.
25