Error Messages; Command Error - Epson ES-300C User Manual

Error Messages

When the scanner detects an error, the display on the control panel
shows corresponding error message.
a
In case of an error, you may need to retry a scanning operation with
the software or reset the scanner. To reset the
wait 10 to 15 seconds, and then turn it on again.
There are three types of errors, as shown below.

Command Error

Error indication:
Possible causes:
To recover:
4-2
Troubleshooting
The error message
light remains on. The scanner waits for a correct
command.
Invalid command is received.
Invalid parameter is received.
Check that the settings on your scanner software
are correct; then retry the scanning operation to
send a correct command. Reset the scanner after
a command error only if necessary.
scanner,
appears. The
E-C
turn it off,
READY