Preparing For A Direct Print Operation; Scanner Settings - Epson ES-300C User Manual

Preparing for a Direct Print Operation

Before starting the direct print function, you need to make the
appropriate settings on the
below, then connect them with
Consult your dealer to obtain the proper parallel interface cable.

Scanner Settings

On the scanner, you have to set the interface direction, printer type,
and scanning functions with the DIP switches. You may also want
to set the zoom and brightness with the control panel buttons before
you start a direct
Setting the interface direction
Set the DIP switch 2-8 to on when you want to use the direct print
function.
Setting the printer type
Set DIP switches SW1-7 and SW1-8 to match the printer type you
are using according to the table below. Do not set combinations
other than those shown below. The LQ-2500 or LQ-2550 printer
setting allows you to print the entire scanning area at the original
image size.
Printer type
Epson LQ-860 (with color ribbon)
HP PaintJet or 3630 color graphics printer
Epson LQ-2500 or LQ-2550 (with color ribbon)
D-10 Direct Print Function
scanner
a
print operation.
and the printer as described
suitable parallel interface cable.
SW1-7
OFF
OFF
ON
SW1-8
OFF
ON
ON